tnc_pi: A Wifi Enabled TNC For Amateur Radio

So, I wanted a wifi-enabled TNC for mobile packet use, and for tooling around at home, while not in the shack.  I also figured eventually, I’d want to not do this all by hand, and I figured others would likely want to do so as well.

So, I’ve release the tnc_pi project into the wild on Github.  Pulls are welcomed, as well as suggestions and enhancements.

You can find the project here:
https://github.com/coreyreichle/tnc_pi

Down the road, what I’d like to add simple web interface to configure direwolf’s modem.  Shouldn’t be too difficult, but it’d take a little work.  Until then, configuration via the command line isn’t insane or anything really.  The config is pretty simple to read.

1 comment on tnc_pi: A Wifi Enabled TNC For Amateur Radio

Leave a Reply

Your email address will not be published. Required fields are marked *